PSI in pressure sensor magic uses mbar

Hey guys, thanks to mzanetti we have PSI as an available setting in the app!

The issue is:

So, lets say you are using PSI and setup some magic to do something, lets say turn on a GPIO when pressure is under 30 psi, you setup the magic and tell it less than 30 PSI to execute somthing.

It says 30 PSI in the magic, as the value…but its actually using 30 mbar. I found this out after playing with it for a while earlier. It does say “psi” when you setup the magic.

I found this out after testing for a while, then the pressure accidentally went so low it went to 29mbar, and boom, the GPIO was triggered!

Changed the value to the equivalent to 30 psi in mbar and now it worked perfect.